Saab Link Forums banner

ASA Type 8

8.7K views 64 replies 23 participants last post by  grkguy89  
#1 ·
so ive been searching for a set of 16x8 wheels for a while
and i found a set of ASA type 8
im picking them up next week

16x8 5x110 ET38 and a 67mm center bore

Image
 
#8 ·
Doing some rough math... wheel is 1" wider, so that's 12.5mm wider inside and outside from center. You have a 38mm offset instead of 49 so they are negative 11mm from stock. Seems like you'd only be 1.5mm closer on the inside edge. Depending on what tire you run, that should be fine. I'd be more worried about the outside edge where you are 12.5+11mm closer to the fender. If you're running lowered, you might want to do some checking.
 
#25 ·
im am going tonight to see the wheels and if everything works out i will be bringing them home to put on my car
i had a spare front hub that i pressed out a while ago for this kind of occasion
that way as to check to see if the wheel fits the hub without needing my car (since its a vert and has no room to haul shit in)
 
#34 · (Edited)
there's a thread somewhere on SC with ride heights
im lower than most, but not the lowest

offset will be somewhere around 30-32 depending on which of my spacers i use, so they will sit nicely on my car

EDIT:
http://www.saabcentral.com/forums/showthread.php?t=220677&highlight=ride+height
So im lower than anyone so far

1995 900s vert vogtlands up front, no name coils in the rear sitting on a 1/2" perch

FH = 11.375"
FF = 24"

Net Front Spring Height (FF Minus FH): 12.625"

RH = 11.5"
RF = 23.375"

Net Rear Spring Height (RF Minus RH): 11.875"

older pic before lowered the rear more (rear tire just starting to tuck into the fender now)
Image