Saab Link Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
1,253 Posts
Discussion Starter · #1 ·
can this be done... the gaskets are exactly the same but will my di cassette be affected by this?
 

·
Registered
Joined
·
3,976 Posts
I would not think that a C900 Valve cover would be a good swap but then again I have never tried it. I think that the mounts for the DI Cassette are different than the cover plate screws on the C900 cover but I will have to double check it. When I get home I will look at my C900 and see how it stacks up compared to the 9-3.

What kind of project where you looking at doing there ricot?
 

·
Registered
Joined
·
1,253 Posts
Discussion Starter · #3 ·
well i can get my hands on one for free and if it fit i would polish it and hand mine over to a buddy with a classic that is going to polish mine and take ecopower off of it so it just says power.... that would be for his c900
 

·
Registered
Joined
·
1,253 Posts
Discussion Starter · #5 ·
like i said im gettin one for free and id rather have one that says saab 16v on it then on that says ecopower..... i am gonna sand most of it down anyway...
 

·
Registered
Joined
·
1,253 Posts
Discussion Starter · #7 ·
y ai cna have it sandblasted for free. but it is the work i like to do though... then i appreciate it a lot more plus my car is parked and has an existing valve cover on it
 

·
Registered
Joined
·
1,253 Posts
Discussion Starter · #9 ·
it works prefectly no problems exact fit... the only difference is when u take it off underneath u will see 2 little pipes that are for ventilation... on some of the older valve covers only have 1 pipe... i dont think this will make a difference... for now i have ablack classic valve cover... and i am polishing another...to replace it....
 
1 - 11 of 11 Posts
Top