Saab Link Forums banner

BBS RKII Bolts

1473 Views 9 Replies 4 Participants Last post by  TheTalladegaKid
2




hjfidjghsafjgjkf!!!

This is going to be a PIA

should I even bother trying to use a backout bit on this or just go find a used RKII
See less See more
1 - 10 of 10 Posts
where can i even find spares?
I would give it a go, which way were you going (taking them out or putting them in)?
at least i know to be careful now...
I was putting them in. Hand tighten all of them and then applied 10lbs per bolt. I should have gone 5lbs 10lbs 15lbs 20lbs in a dual star pattern
think its safe to drive on 2 missing bolts???
Were those new? If I recall they are to be replaced and not reused. Take the wheel to a machine shop to have them extract the broken bits and call BBS for new bolts...
Were those new? If I recall they are to be replaced and not reused. Take the wheel to a machine shop to have them extract the broken bits and call BBS for new bolts...
no they were the original bolts. i over torqued them...
yeah ill have to give them a call. hopefully i dont have to buy a complete set.
BBS will not sell me screws because its a liability for them.
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top