The Saab Link Forums - Search Results

Go Back   The Saab Link Forums > Search Forums

SaabLink.net is the premier Saab Forum on the internet. Registered Users do not see the above ads.
Showing results 1 to 25 of 42
Search took 0.02 seconds.
Search: Posts Made By: theanswer1nba
Forum: General New 9-3 Posts and Information 03-20-2016, 05:44 AM
Replies: 1
Views: 1,076
Posted By theanswer1nba
03 9-3 with p1312 code

Hey so my 9-3 linear starts and runs poorly during warm up. Cold start it sputters badly but never stalls. Once up to operating temp, couldn't even know it had an issue. It finally threw a code...
Forum: General 9000 Posts and Information 09-28-2014, 06:57 AM
Replies: 1
Views: 452
Posted By theanswer1nba
Interior Lights not working

Hey so on my 97 9000 yesterday morning I went to go start my car and battery was dead. Parked at work and then it died again. Battery testest good. I swapped out the alternator real quick. Then I...
Forum: General 9000 Posts and Information 06-28-2014, 05:22 PM
Replies: 0
Views: 717
Posted By theanswer1nba
Shift Linkage Adjustment?

I just installed a 5 speed on my 97 9000 cse and I need to adjust the shift linkage a little more. I didn't get it perfect- Can not get into reverse and must use lockout to enter 5th gear. What is...
Forum: General 9000 Posts and Information 06-28-2014, 05:16 PM
Replies: 12
Views: 1,880
Posted By theanswer1nba
I ended up gravity bleeding and the next morning...

I ended up gravity bleeding and the next morning it was perfect.
Forum: General 9000 Posts and Information 06-25-2014, 04:46 PM
Replies: 12
Views: 1,880
Posted By theanswer1nba
I did not bench bleed the slave. I am probably...

I did not bench bleed the slave. I am probably going to make a pressure adaptor and then bleed the rest off.
Forum: General 9000 Posts and Information 06-25-2014, 01:46 PM
Replies: 12
Views: 1,880
Posted By theanswer1nba
Can you tell me more? I am at the point where I...

Can you tell me more? I am at the point where I have gravity bled it for hours and did the usual procedure and still no pressure is building. Res is full and there are no leaks. I can't seem to make...
Forum: General 9000 Posts and Information 06-25-2014, 10:18 AM
Replies: 12
Views: 1,880
Posted By theanswer1nba
Bleeding the clutch

Hey so this is a big topic as I see. There seems to be a lot of different ways to bleed the clutch. Some say the common way work and some say gravity bleeding or pressurizing works good. What have...
Forum: General 9000 Posts and Information 06-10-2014, 01:42 PM
Replies: 0
Views: 479
Posted By theanswer1nba
Help!!Speedometer drive gear issue

Hey guys, so last week my 2nd gear synchro gave up on my '97 CSE. Lucky I have a spare gearbox from my parts car (speedometer did not work on parts car) I removed the speedometer drive gear and seal....
Forum: General New 9-3 Posts and Information 05-20-2014, 12:11 PM
Replies: 7
Views: 2,371
Posted By theanswer1nba
Mike D I am hearing now that it is not possible...

Mike D I am hearing now that it is not possible to marry a t8 ecu. Is this true?
Forum: General New 9-3 Posts and Information 05-19-2014, 02:46 PM
Replies: 7
Views: 2,371
Posted By theanswer1nba
Alright looks like I'm going to the GM dealer....

Alright looks like I'm going to the GM dealer. Hopefully it fixes the issue. Ecu is suspected to be faulty.
Forum: General New 9-3 Posts and Information 05-19-2014, 01:24 PM
Replies: 7
Views: 2,371
Posted By theanswer1nba
Marrying ECU? 03 Saab 9-3

Quite sure my ecu has a intermittent issue causing a no start. Getting a new ecu "used" but I hear you need to marry it with a Tech 2. Does it need to be a Tech 2 or can you also use other scan...
Forum: Car Problems? New 9-3 Only 05-18-2014, 09:17 AM
Replies: 2
Views: 1,150
Posted By theanswer1nba
Yeah I am about 3 hrs north from him.

Yeah I am about 3 hrs north from him.
Forum: Car Problems? New 9-3 Only 05-18-2014, 04:27 AM
Replies: 2
Views: 1,150
Posted By theanswer1nba
Check Engine light and No start

03 Saab 9-3 linear is throwing these codes: P137 (oxygen sensor), P201, P202, P203, P204 (injector malfunction) At the moment the car will not start. This happens intermittently, it seems like it...
Forum: General 9000 Posts and Information 09-19-2013, 09:37 AM
Replies: 6
Views: 1,326
Posted By theanswer1nba
Nope I already changed the cv shaft. I had the...

Nope I already changed the cv shaft. I had the same issue finding one with the right tripod. So I just swap the old tripod back in. But I'm talking about the whole drive axle and inner driver needs...
Forum: General 9000 Posts and Information 09-17-2013, 02:44 PM
Replies: 6
Views: 1,326
Posted By theanswer1nba
Axle Seal?

Hey so my right side axle seal is leaking pretty good right now. Getting ready to replace it and wanna be sure of what the job consists of. So I know once you take the axle nut off, loosen the ball...
Forum: General 9000 Posts and Information 05-01-2013, 09:09 AM
Replies: 19
Views: 1,997
Posted By theanswer1nba
Anyone?

Anyone?
Forum: General 9000 Posts and Information 04-22-2013, 08:08 AM
Replies: 19
Views: 1,997
Posted By theanswer1nba
Here is a video I took this morning. You can kind...

Here is a video I took this morning. You can kind of hear it. Sorry about the video quality was trying to hold my camera and get good audio. Saab 9000 turbo noise? - YouTube
Forum: General 9000 Posts and Information 04-21-2013, 05:19 PM
Replies: 19
Views: 1,997
Posted By theanswer1nba
I don't know about a police siren. But it's more...

I don't know about a police siren. But it's more of a constant whiny noise. Gets a tad bit louder the more I push down til the exhaust and intake noise over comes it
Forum: General 9000 Posts and Information 04-21-2013, 03:29 PM
Replies: 19
Views: 1,997
Posted By theanswer1nba
More noticeable under load. I checked that too...

More noticeable under load. I checked that too and had no excessive play seemed fine. Charges fine and doesn't make noise in that area. Yeah ill pop it off and check.
Forum: General 9000 Posts and Information 04-21-2013, 03:12 PM
Replies: 19
Views: 1,997
Posted By theanswer1nba
Ok just did that but didn't really notice...

Ok just did that but didn't really notice anything. When I did my pulleys I checked my water pump and ac pulley. Both spun freely and no bearing play. Un sure about the turbo. Been making this noise...
Forum: General 9000 Posts and Information 04-21-2013, 02:25 PM
Replies: 19
Views: 1,997
Posted By theanswer1nba
Im not exactly sure where its coming from. I dont...

Im not exactly sure where its coming from. I dont think its the A/C compressor because wouldn't it alway make the noise? When I let off the gas it goes away. Its like its almost vacuum related. When...
Forum: Performance Modifications for the 9000 04-21-2013, 12:41 PM
Replies: 12
Views: 5,077
Posted By theanswer1nba
I did a T7 conversion. I swapped the BCV to a Mac...

I did a T7 conversion. I swapped the BCV to a Mac valve off ebay. And got a 3 pin connector to connect to the harness on the car. Let me know if you want the links to all the parts. Highly...
Forum: General 9000 Posts and Information 04-21-2013, 12:33 PM
Replies: 19
Views: 1,997
Posted By theanswer1nba
No boost leaks. and at idle I have about 20-22...

No boost leaks. and at idle I have about 20-22 lbs of vacuum. Hold pressure good. Its a full pressure turbo;T-25. Car has 219xxx on it right now. Im just not sure if its normal. I was thinking could...
Forum: General 9000 Posts and Information 04-21-2013, 10:05 AM
Replies: 19
Views: 1,997
Posted By theanswer1nba
Turbo noise?

Hey guys wondering if this normal noise. Lets say I'm driving in any gear I hear a light whining and goes away when I let off the gas. Generally happens at 10-15 lbs of vacuum not at boost. I can't...
Forum: General 9000 Posts and Information 04-16-2013, 06:50 PM
Replies: 10
Views: 3,088
Posted By theanswer1nba
Yeah I saw that Wurth paint but Im not really...

Yeah I saw that Wurth paint but Im not really looking to paint with a rattle can if possible. If I bring it to a shop they can mix something up so I can shoot them?
Showing results 1 to 25 of 42

 
Forum Jump

All times are GMT -8. The time now is 08:10 PM.


Powered by vBulletin® Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.5.2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
All content is copyright The Saab Link and it's original authors.


 

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.