The Saab Link Forums - Search Results

Go Back   The Saab Link Forums > Search Forums

SaabLink.net is the premier Saab Forum on the internet. Registered Users do not see the above ads.
Showing results 1 to 25 of 500
Search took 0.37 seconds.
Search: Posts Made By: GenuineSaab
Forum: Performance Modifications for the NG900 / Old 9-3 01-06-2012, 01:57 PM
Replies: 39
Views: 1,878
Posted By GenuineSaab
David, If you want to pay shipping I can loan...

David, If you want to pay shipping I can loan you my 24.5" slicks. But you better have a quiafe or the spider gears tend to show themselves.
Forum: General NG900 / Old 9-3 Posts and Information 01-05-2012, 08:02 AM
Replies: 17
Views: 3,550
Posted By GenuineSaab
Saab didn't raise prices on the january...

Saab didn't raise prices on the january pricefile. I was worried about that but it didn't happen.
Forum: Performance Modifications for the NG900 / Old 9-3 12-30-2011, 05:39 AM
Replies: 398
Views: 43,556
Posted By GenuineSaab
If you deck the block and head to a perfect...

If you deck the block and head to a perfect surface finish .,. Not Ground but a smooth enough your fingernail can't feel it you should be good. More critical on the T7 gaskets and higher cylinder...
Forum: Performance Modifications for the NG900 / Old 9-3 12-29-2011, 05:46 AM
Replies: 7
Views: 947
Posted By GenuineSaab
To get the "boost" gauge working in my T5...

To get the "boost" gauge working in my T5 converted NA it required a wire from the 33pin under dash to the back of the main instrument. It was pink on the -95

I assume its the same for the APC...
Forum: N/A Performance Modifications for the NG900 / Old 9-3 12-28-2011, 01:12 PM
Replies: 4
Views: 2,680
Posted By GenuineSaab
LEt it idle and warmup in the free time today...

LEt it idle and warmup in the free time today made a couple more passes.

Repeated previous best after 2 runs. Gearbox was a bit cool first pull. oil was 190 to start.

Filter off, Lost...
Forum: General Classic 900 Posts and Information 12-28-2011, 12:37 PM
Replies: 18
Views: 1,564
Posted By GenuineSaab
The shellbys were Saab USAs cheaper option to...

The shellbys were Saab USAs cheaper option to replace the Ronal Wheels. They actually went to all the trouble of getting them OEM tested etc. Thats why the shelby had cast finish with machined...
Forum: Performance Modifications for the NG900 / Old 9-3 12-28-2011, 12:35 PM
Replies: 5
Views: 749
Posted By GenuineSaab
You will also find quite a bit of tolerance in...

You will also find quite a bit of tolerance in tire pressure gauges.

A few times a year we usually calibrate all the dyno pressure channels and various gauges in the shop. The tire gauges tend...
Forum: Car Problems? NG900 or old 9-3 Only 12-28-2011, 06:59 AM
Replies: 23
Views: 4,327
Posted By GenuineSaab
On t7 Tq managed by gear, If you get slip in...

On t7 Tq managed by gear, If you get slip in the clutch the gear position calculated is lower than actual. So slip in 3rd the ecu reduces tq to 2nd gear limits and the slip is gone. ;)
Forum: Car Problems? NG900 or old 9-3 Only 12-27-2011, 06:58 AM
Replies: 23
Views: 4,327
Posted By GenuineSaab
Saab wty time is 5 hours. If there is not too...

Saab wty time is 5 hours. If there is not too much rust/ torn up spoiler etc it can be done under that. 400 is a reasonable number. Plus flywheel machine and 450 or less sounds right.
Forum: N/A Performance Modifications for the NG900 / Old 9-3 12-27-2011, 05:58 AM
Replies: 4
Views: 2,680
Posted By GenuineSaab
I didn't extend the VE up there yet. Need to...

I didn't extend the VE up there yet. Need to move some rows around.. In the middle around 4500 the resonances really mess with the AF. My timing table goes to 7500 and accommodates that burn rate...
Forum: N/A Performance Modifications for the NG900 / Old 9-3 12-23-2011, 03:59 PM
Replies: 4
Views: 2,680
Posted By GenuineSaab
2.3i, meet Enem 264 Cams...

So with the 264 9.6 cams temporarily out of of my Viggen curiosity got the better of me and I threw them in the NA project car. With the big port CNCd T7 head, large runner intake etc and every...
Forum: TSL Member's Saab pics 12-23-2011, 05:23 AM
Replies: 182
Views: 21,871
Posted By GenuineSaab
My new roofrack holder ...

My new roofrack holder

http://genuinesaab.com/gallery/albums/TurboX01/IMG_0198.jpg
Forum: Car Problems? NG900 or old 9-3 Only 12-22-2011, 03:28 PM
Replies: 5
Views: 1,208
Posted By GenuineSaab
Thermostat is built into the oil filter housing...

Thermostat is built into the oil filter housing bolted to the block. It is under the large hex nut, something like 24mm.
Forum: Site Problems? 12-20-2011, 07:59 AM
Replies: 8
Views: 878
Posted By GenuineSaab
safari plus adblock.. ;)

safari plus adblock.. ;)
Forum: Performance Modifications for the NG900 / Old 9-3 12-15-2011, 06:06 AM
Replies: 72
Views: 5,237
Posted By GenuineSaab
Actually it allows them to have an increasing...

Actually it allows them to have an increasing spring rate. This allows it to settle to desired height when lowered to the ground but increase the spring rate from there to prevent further...
Forum: Performance Modifications for the NG900 / Old 9-3 12-14-2011, 11:44 AM
Replies: 72
Views: 5,237
Posted By GenuineSaab
The cars locally we have done with koni all...

The cars locally we have done with koni all looked great. One with a heavy stereo setup could have used a spacer on full tank. 15gallons of fuel is pretty heavy.

Plenty of koni stuff in stock.
Forum: General 9000 Posts and Information 12-08-2011, 01:48 PM
Replies: 5
Views: 1,425
Posted By GenuineSaab
Led with proper resistor. Then it will last and...

Led with proper resistor. Then it will last and be functional. Good winter project. ;)
Forum: Performance Modifications for the NG900 / Old 9-3 12-07-2011, 08:00 AM
Replies: 466
Views: 60,184
Posted By GenuineSaab
More agressive cams will generally shift the...

More agressive cams will generally shift the power band up in the revs. Also with the high backpressure of your setup it is not the best idea to increase overlap and exhaust duration. Keep the...
Forum: Performance Modifications for the 9-5 12-01-2011, 06:00 AM
Replies: 7
Views: 1,039
Posted By GenuineSaab
We found after spending a day on the dyno with a...

We found after spending a day on the dyno with a stg+ Viggen and aquamist mapping it with the Uhrs from Sweden that the water/meth showed up as knock, only way around it was killing knock control a...
Forum: Performance Modifications for the New 9-3 11-28-2011, 01:14 PM
Replies: 8
Views: 1,139
Posted By GenuineSaab
The other cable end is the lateral throw. Some...

The other cable end is the lateral throw. Some models that is solid, Others like this V6 are both isolated. Yes I have one for that too had to take it off for the video. Same piece won't fit both,...
Forum: Performance Modifications for the New 9-3 11-23-2011, 02:26 PM
Replies: 8
Views: 1,139
Posted By GenuineSaab
New intake for my tX

We worked on a new intake this week. Here is the ugly first part. To check install etc. Used a huge oval filter. The KN has tougher rubber base. Similar to the custom SB filters we have made for...
Forum: Customizing Your Saab 9000 11-23-2011, 06:00 AM
Replies: 23
Views: 3,398
Posted By GenuineSaab
I did texture black like the valve cover for my...

I did texture black like the valve cover for my viggen intake manifold.. It just blends in.

Another option might be red to match the DI but that is a hard challenge, I tried to match it for a...
Forum: General NG900 / Old 9-3 Posts and Information 11-17-2011, 01:18 PM
Replies: 140
Views: 10,079
Posted By GenuineSaab
That :06 was just being in a hurry editing it out...

That :06 was just being in a hurry editing it out the incriminating bits.. The front doesn't rub. Rear touches with full passengers and full compression where it is smashing the rear bump rubbers.
Forum: General NG900 / Old 9-3 Posts and Information 11-17-2011, 12:48 PM
Replies: 140
Views: 10,079
Posted By GenuineSaab
In for this also.. If you don't have a gopro...

In for this also.. If you don't have a gopro sure you can borrow one.
Viggen Coilover Suspension - YouTube
Forum: General 9-5 Posts and Information 11-17-2011, 10:41 AM
Replies: 11
Views: 2,471
Posted By GenuineSaab
Could probably retrofit one to the 4 if you could...

Could probably retrofit one to the 4 if you could find a place to fit the pump. Then reprogram acc to that option.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 05:42 AM.


Powered by vBulletin® Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.5.2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
All content is copyright The Saab Link and it's original authors.


 

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.