|06-20-2005 06:18 AM|
|abdukted1456||oh sorry, I thought you had a 9-3 SE. maybe I better pay attention.|
|06-18-2005 03:38 PM|
Just pull the black box
out ( the one with the clips ) install the heat shield then just screw on the cone like i did , drive around for a couple of hours disconect you battery over night so the computer can learn the new filter
|06-17-2005 07:38 PM|
Here's the V6 engine for reference
|06-17-2005 05:37 PM|
I should be alright with the intake. I haven't posted any pics of my car yet, so here goes.
EDIT: She's a bit dirty, dirt roads will do that .
|06-17-2005 04:15 PM|
|danthegolfer||o my bad i wasnt aware he had the v6...|
|06-17-2005 02:47 PM|
Yeah the V6 is a totally different engine Dan.
Post a pic of it for us please.
|06-17-2005 02:40 PM|
I don't have the same engine as you, so I dont' have that black box above my engine where yours is. I believe my resonator box is below my filter box, will have to investigate. Thanks for the replies though.
|06-17-2005 01:00 PM|
ok hold on...
i think the "resonator box" that he is referring to is the air filter box...
heres hwo the intake works, air goes into the inlet tube and thru that first box, the air filter is inside it... then it goes out the other end of the airbox and through a rubber bendy tube into the resonator box, which sits ontop of the throttle body. then the air goes into the throttle body and then into the engine....
if you were to get a cone filter, you would need to take that whole airbox off, but also get some new piping so your filter isnt pulling in hot engine air...
on my below picture, the green arrow is the air filter box, the red arrow is the air resonator box
on the other picture, that is how you would set up the cone filter intake
but, also go to this thread b/c this is the best intake setup of them all
|06-17-2005 10:28 AM|
|abdukted1456||I forgot to tell you. you have it right but where does it go? one side draws air from the wheel well the other side goes up to the airbox.|
|06-17-2005 10:22 AM|
Ok, thanks man.
|06-17-2005 10:16 AM|
|abdukted1456||you got it chief.|
|06-17-2005 09:39 AM|
I've searched on this topic, and I found some answeres, but I still didn't get a clear understanding of how the resonator works. So there's a tube that runs from near the wheel well. This tube runs into the resonator box, then another tube comes out, and goes where? If I'm getting a cone for my intake, I can simply take out the whole box altogether, right?