|01-17-2014 02:57 PM|
Mail in lightening for about 200. I'm planning on sending the v6 one in (it is super heavy). I can't find anybody local that will do it that I feel comfortable with. These guys (I've called them) seem like they know what they're doing.
Might be out of service for a bit if it is you dd.
|01-17-2014 09:09 AM|
I was upgrading to a Viggen clutch for my Stg3 2.0, so I wanted to do everything once.
I agree with most of what's been said here. Always, always resurface.
|01-11-2014 02:47 AM|
|bogan||yeap ...resurface 100 %|
|01-10-2014 03:59 PM|
|Drew in Houston||Always always always always resurface your flywheel when replacing your clutch. Always.|
|01-10-2014 03:30 PM|
|Ashbypa||pretty sure it was 50. They should resurface the clutch contact surface as well as the pressure plate mounting surface to maintain dimensions.|
|01-10-2014 02:45 PM|
|Progression||What is a typical cost to expect to pay for a surfacing of the flywheel and typical cost of a lightening of the flywheel?|
|09-27-2013 07:12 PM|
Read page one of this .. It has how I replaced my rear main seal .. a while back
|09-27-2013 02:22 PM|
Thanks. I ended up taking it in. For 40 bucks it was piece of mind.
However the shop owner was able to show me that while it looked clean and flat, it was actually worn at a very minor angle - like a cone. More space on the outer edge than inner. While minor, it'll be good to be perfectly flat.
Now how to pull the rold rear main seal....
|09-27-2013 01:36 PM|
|daniel||if surface is not gouged up leave alone i never mechined flywheel ever leave alone|
|09-27-2013 07:58 AM|
|9ryan3viggen||Do it, it is cheap and a MUST DO.|
|09-27-2013 07:25 AM|
|lms||Do it, it's one of those while you are in there things. I did not once and regretted it.|
|09-27-2013 03:18 AM|
Flywheel - to resurface it or not...
So, replacing the clutch.
Got the old off and was surprised to see how clean/smooth the flywheel is.
Still can see semblance of the original machining.
Since my machine shop wont lighten it (they don't want to be responsible for future cracking etc.) - I am not sure whether I really need/want to have it machined.
Its doesn't cost much, money isn't the issue. But it doesn't "seem" like its needed.