The Saab Link Forums

The Saab Link Forums (https://www.saablink.net/forum/index.php)
-   General NG900 / Old 9-3 Posts and Information (https://www.saablink.net/forum/forumdisplay.php?f=23)
-   -   El Diablo Possessed Me (https://www.saablink.net/forum/showthread.php?t=97569)

Cm452 11-11-2014 10:16 PM

El Diablo Possessed Me
 
El Diablo cutting heads for a Sawzall that is...
Transmission bushing NO CUTTING how-to - SaabCentral Forums
Attempted this job and after hours of beating the shit out of the slide hammer, including with a weird sling system, as well as a slingshot system with a crapload of bungee chords, I gave in and loaded up a Sawzall El Diablo metal cutting blades to got that effing bushing out...worked well, too well. I ended up cutting the actual bearing race about 1mm deep near the inside, tapering off to a surface graze near the outside. I then pressed in the new bushing over it.

Will this structurally compromise the bearing to the point where it is dangerous?
How bad did I screw it up?
Thanks,
Cm
BTW, it made a HUGGGE difference in play in the front axle...nice-n-tight now.


All times are GMT -8. The time now is 03:14 PM.

Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.5.2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
All content is copyright The Saab Link and it's original authors.


Garage Plus vBulletin Plugins by Drive Thru Online, Inc.