Innovate LC-1 Users: Help!
I was curious as to whether after bench calibrating both the wide band processor and the sensor whether or not I'd have to do it again once i transplanted to the car. I'd think not because the manual calls for a switched 12v source, but I'd rather know for sure before I wire everything up.
While I'm at, since ecu project is down I'll ask here; once everything is in place, how did you get T5 suite and the Lc-1 to communicate and agree with each other? I know you select the 69th pin input and how to work the realtime panel. I just remember reading that certain values had to be entered in to configure the two so it didn't read artificially rich or lean.