The Saab Link Forums - View Single Post - Cel Blink Code??
View Single Post
Old 05-12-2007, 03:19 PM   #7
Newf9000
Flirting With TSL Addiction
 
Newf9000's Avatar
 
Join Date: Oct 2005
Location: Newfoundland, Canada
Posts: 504
From saab9000.com....

Procedure (DI/APC)

To obtain a fault code reading:

1. Turn the ignition switch to the Drive position without starting the engine.
2. In about two seconds the CHECK ENGINE light will go out for about 2 seconds. It will then begin flashing the fault code.

Fault codes (DI/APC)

Fault code/ Fault
2 Internal memory check failed

3 Watchdog (control module fault).
May also be caused by a defective spark plug or ignition module.

4 Knock sensor

5 Engine load signal from LH or MAP sensor incorrect
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Newf9000 is offline   Reply With Quote